Richmar Home Ultrasound 1000 – 3rd Edition

The Richmar US 1000 3rd Edition offers effective ultrasound therapy by generating deep ultrasonic waves within body tissues to treat pain, muscle spasms and joint stiffness. The portable unit comes as a complete kit with carrying case, AC adapter, ultrasound gel, and manual.

3 duty cycles including 8%, 14% and 29%. Works at a 1 MHz Frequency. Maximum intensity level: 0.65 W/cm² +/- 20%

In stock

The Richmar home ultrasound 1000 – 3rd Edition is a therapeutic ultrasound device that generates deep ultrasonic waves within body tissues to treat pain, muscle spasms, and joint stiffness. This modality is commonly used in physiotherapy, chiropractic clinics and by athletic therapists for various injuries.

Unlike electrical modalities, ultrasound is unique in that the longitudinal waveform associated with sound is not electromagnetic in nature. The piezoelectric crystal converts electrical energy into a strong vibratory sound wave, or ultrasound, a sound beyond the normal range of human hearing. Sound waves cause vibration in soft tissue cells, increasing temperature, and inducing vasodilation, to give you the relief you need – all controllable with 3 different power output settings!

Treatment duration and settings can be determined by your health care practitioner. We also offer free advice from our physiotherapists to our customers who have purchased a home ultrasound unit.

Treatment duration ranges from 5-15 minutes depending on the conditions treated and anatomic target site. Because air is a very poor sound conductor, you require ultrasound gel between the head of the ultrasound and the skin to conduct the sound wave energy to the skin.

Richmar Home Ultrasound 1000 Features

Therapeutic ultrasound device that generates deep heat within tissues of effected area
Device must be used with ultrasound gel to conduct the ultrasound energy to the skin
Three power output settings
Auto Time setting: 30 minutes
1 Year Manufacturer Warranty
Doctor Recommended and Patient Trusted
Package includes everything needed to start treatment right away:
- 1x US 1000 3rd Edition
- 1x AC Adapter
- 2oz Tube of Ultrasound Gel
- Hard Plastic Carrying Case
- Instruction Manual

Richmar Home Ultrasound 1000 Specifications

Power Source: AC Adapter – 100-240 Volts AC Input (DC 15V)
Frequency: 1.0 MHz ± 10%
ERA Treatment Area: 6.16 cm² ± 20%
Temporal Maximum Power: 4W ± 20%
Output Mode: Pulsed
Maximum Output Intensity: 0.65W/cm²
3 Duty Cycles: 8% (Low), 14% (Medium), 29% (High)
Pulse Width:
- Low: 8% 0.5mS ± 10%
- Medium: 14% 1mS ± 10%
- High: 29% 2mS ± 10%
Repetition Rate: 150Hz ± 10%
Material of Applicator: Aluminum
Beam Type: Collimated

Directions on How to Use Your Home Ultrasound

Connect power wire to wire socket.
Connect AC adapter to power.
Apply sufficient gel to skin at target area.
Switch on the power. It power signal light is on, start to use Portable Ultrasound.
Place the treatment head on the skin and move it slowly over the target area in a circular motion or in linear strokes at a rate of about 1 inch per second. DO NOT stop moving treatment head while in use.
Use special care on bony prominence’s to avoid discomfort.
The power automatically turns off in 10 minutes or, if desired, the power can be turned off sooner by pushing the ON/OFF switch to OFF.
After using the US-1000, clean skin with water to remove gel.
Wipe excess gel off the treatment head with a damp cloth. Disinfect treatment head with antiseptic wipe. Do not immerse treatment head in water or solvent.
When power shuts off, leave unit off for 30 minutes before restarting unit.
After every treatment, disconnect AC adapter from power source.
Do not impact the treatment head or drop treatment head on the floor.